ENGLISH
CONTACT US
Charcoal machine production line in the mill is responsible for the size of raw materials, the raw materials crushed to 1-3MM to ensure the formation of salary sticks. Crusher in the daily operation of a variety of situations, we need our repair and maintenance, Here we come to teach you about the maintenance of charcoal grinder coup.
1, turn on the power to see if the turn is correct.
2, replace the tool, the knife blade plane 2-4mm, and then tighten the bolt. Found that the pressure screw threaded wear, should be replaced immediately to prevent damage to the slider nut. Wood mill does not change the use of power and speed, sharpening angle, maintaining the original straight line 28-30 °.
3, change the degree of retractable knife, must be the same length of the retractable knife.
4, by adjusting the length of the knife, the particles do not reach the ideal, the change of different aperture Luo sieve. Need to change Luo, adjust the knife at the same time, Luo Kong smallest not less than 14mm (diameter), the largest not more than 20mm (diameter), the length of the knife between 3-6mm, bottom knife and knife gap is not more than 1mm.
5, no entrainment of stones, nails of firewood into the machine, to prevent damage to the knife and the inner pieces.
6, pay attention to check the hammer bolts, found loose, immediately fastened, hammer and bolt wear serious, should be replaced.
7, sharpening angle of 28-30 ° straight line, non-ground into a convex surface, the convex edge will lead to the steel edge from or partial exposure to the steel.
8, frequently used machine should check whether the lack of bearing butter. Should be 3-4 hours to add butter once, add butter is not easy too much.
1, turn on the power to see if the turn is correct.
2, replace the tool, the knife blade plane 2-4mm, and then tighten the bolt. Found that the pressure screw threaded wear, should be replaced immediately to prevent damage to the slider nut. Wood mill does not change the use of power and speed, sharpening angle, maintaining the original straight line 28-30 °.
3, change the degree of retractable knife, must be the same length of the retractable knife.
4, by adjusting the length of the knife, the particles do not reach the ideal, the change of different aperture Luo sieve. Need to change Luo, adjust the knife at the same time, Luo Kong smallest not less than 14mm (diameter), the largest not more than 20mm (diameter), the length of the knife between 3-6mm, bottom knife and knife gap is not more than 1mm.
5, no entrainment of stones, nails of firewood into the machine, to prevent damage to the knife and the inner pieces.
6, pay attention to check the hammer bolts, found loose, immediately fastened, hammer and bolt wear serious, should be replaced.
7, sharpening angle of 28-30 ° straight line, non-ground into a convex surface, the convex edge will lead to the steel edge from or partial exposure to the steel.
8, frequently used machine should check whether the lack of bearing butter. Should be 3-4 hours to add butter once, add butter is not easy too much.
