ENGLISH
CONTACT US
Hammer crusher or put into production use in the design process should be carried out before the the corresponding simulation design stage. Hammer crusher ore realistic image simulation. Simulation process, we can clearly see the overall condition and working principle of hammer crusher crushing ore process: According to the connection between the simulation motor and hammer crusher assembly and conveyor belt moving process, we can all observe work assembly relationships between the various devices. Hammer crusher is often used in the design and manufacturing process of three-dimensional modeling techniques, the combination of the various components of the device in order to clear observation is reasonable, the ability to successfully complete tasks. Modeling first modeling of parts and components. The component modeling including rack parts, eccentric shaft parts, hammerhead, and other components, and finally integrated assembly modeling, the effect of the overall design of the observation equipment. In the the 3D general assembly of the hammer crusher. Hongxing Machinery experts use a bottom-up assembly design ideas. The so-called bottom-up is the use of already established good part design assembly. Assembly design is like an assembly shop, we can simply use the finished parts, according to the different locations where components and assembly constraints between each part assembled, and ultimately the formation of the entire device. Observed during the simulation in order to dynamically during operation of the device. Before final assembly, we must first distinguish clearly between the parts of the device, which is fixed pieces what is movable parts. The general no moving parts can be assembled into equipment rack components In order to clearly understand the specific work through the simulation process, we will as far as possible the crusher simplify simulation set during the adjustment bolt is set to a non-movable member.
